23
Optional Accessories
EAS-2584 Bottom Plate
When measuring workpiece
surfaces with the Pocket Surf
probe in the “Closed” position,
the EAS-2584 Bottom Plate will
accommodate cylindrical
workpieces too short (less than
3½"/89mm long) to span the “V’s”
on the bottom of the Pocket Surf
housing.
The Bottom Plate accommodates
cylindrical workpieces from
¼"/6,35mm diameter up to
1½"/38mm long — long enough to span
the slot lengthwise and sit securely in the
“V” of the Bottom Plate.
To install the Bottom Plate, remove the
Protective Cover from the Pocket Surf
unit and turn the Pocket Surf unit upside
down. Loosen the Clamping Screw on
the side of the Bottom Plate and
position the Bottom Plate over the base
of the Pocket Surf unit between the two
“V’s”. Tighten the Clamping Screw
finger tight only; do not overtighten
.
Minimum Length
