Mahlkonig K30 TWIN, Оригинальное руководство пользователя

Страница: 26 / 36

Fault Cause Remedy
• A foreign object is
in the grinder.
 Clean the grinding gear as de-
scribed in the chapter “Clean-
ing” and remove the foreign
object at the same me. If
the foreign object cannot be
removed, contact your suppli-
er using the address indicated
in the chapter
“
Service
”
.
The grinder is
not grinding, the
display is lit up,
the grinding
mode has been
selected.
• The grinding me
has been set to 0.1
second.
• The maximum op-
era ng cycle has
been exceeded.
 Reset the grinding me.
 Wait un l the grinder has
cooled down again.
The grinder is not
switching on; the
display is not lit
up.
• The power plug is
not plugged into a
socket.
 Insert the power plug into a
properly installed socket.
• The overcurrent
protec on was
triggered.
 Contact your supplier using
the address indicated in the
chapter “ Service ” .
Troubleshoo ng using the display
Fault Cause  Remedy
“FALSE DATA,
DATA MISSING”
appears on the
display
• Programmed data
has been lost.
 Press the Prog bu on. Grind-
ers are not blocked
“GRINDER X
BLOCKED”
appears on the
display
• Current consump-
on higher than
the limit value