|
L A D E N M Ü H L E N
S H O P G R I N D E R
During re-assembly, no ground material should stick
to the surfaces where the grinder casing and the
grinder casing touch each other.
9. Screw down the grinder casing cover (12) tightly with the two
screws (13) while changing the side several times.
10. Plug in and switch on the grinder with the setting still at coarse.
11. Slowly turn the rotary knob to fine to make sure the discs are not
touching.
12. Rotate the rotary knob back to the desired grind degree. The grinder
is now ready for operation again.
10. Maintenance and Repair
Always pull the power supply plug out of the outlet
before carrying out any maintenance or cleaning
work on the device!
Check the device regularly for any signs of damage
on the power supply cable, plug, finger protector, etc.
Any repairs that may be required are only allowed to
be carried out by authorised experts. Please contact
an authorised customer service centre or your local
dealer.
10.1 Grinding Disc Replacement
If the grind capacity decreases and the ground coffee is hot and of irregu-
lar grind size, you should change the grinding discs.
1. Take the grinder apart as described in para. 9.3 and remove the
grinding discs from the grinder casing and the pre-breaker using a
screwdriver.
2. Clean the surfaces of the new grinding discs thoroughly and screw
them in position tightly and evenly.
3. Close the grinder casing again as described in para. 9.3 and set the
grind degree again as described in para. 8.
11. Spare Parts
Spare parts are usually ordered from your customer service centre or
your local dealer. To ensure quick, correct processing of your order, the
following information is absolutely required:
1. Type designation and serial number of the grinder
(on the rating plate on the rear side of the grinder).
2. Color of the grinder
page 12
Coffee Laboratory 589 Rappahannock Drive White Stone Va 22578 TEL (866) 244-1578 www.coffeelabequipment.com
