Maintenance Manual
MAN-00
167
XYLO
mHawk
February 2012/ Rev1
The repair methods given by the manufacturer in this document are based on the technical specifications
,
current at the time of release. The methods may be modified as a result of changes introduced by the
manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part of
or
whole of the present document,
are prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any person other than the trained personnel, at the Authorized Service Centre of Mahindra & Mahindra
Ltd., will amount to unauthorized use and shall be liable for penalty/prosecution
© 2012 Mahindra & Mahindra Ltd.
Head Lamp Alignment Procedure –
STEP 1 – Se
tti
ng the Low Beam
STEP 2 – Checking High Beam
STEP 1 – Low Beam Se
tti
ng Procedure:
Refer below illustra
ti
on for the headlamp low beam cut o
ff
pa
tte
rn:
Xylo Head Lamp alignment Dimensions are -
X: 869mm. h=(X-130)=739mm. Z: 1261mm.
h=X-1.3% of Y. Y=10meters (distance between vehicle and board)
Set LH & RH head lamp (Low Beam) by s
etti
ng the cut o
ff
pa
tte
rn at a height marked on the board.
Refer above illustra
ti
on for low beam cut o
ff
pa
tte
rn.
Xylo LH side head lamp – Rear View
Refer illustra
ti
on for LH & RH side head lamp low
beam alignment se
tti
ng.
•
Use 250mm size star screw driver and set
screw [A] to adjust low beam ver
ti
cal
movement.
A
Page 56
h
