Maintenance Manual
MAN-00
167
XYLO
mHawk
February 2012/ Rev1
The repair methods given by the manufacturer in this document are based on the technical specifications
,
current at the time of release. The methods may be modified as a result of changes introduced by the
manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part of
or
whole of the present document,
are prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any person other than the trained personnel, at the Authorized Service Centre of Mahindra & Mahindra
Ltd., will amount to unauthorized use and shall be liable for penalty/prosecution
© 2012 Mahindra & Mahindra Ltd.
712-MAT-0037 : 0.65 hrs
DOOR SETTING
DOOR STRIKER
DOOR LATCH
STRICKER MOUNTING SCREW -
LOOSEN
Door Setting - For Side doors
:
Refer photos shown.
1.
Open the door and while closing it check whether striker is at the centre of latch. If it is
not at the centre of latch, striker will foul with top or bottom portion of latch. Loosen the
bolts of striker and move the striker up or down to remove the fouling.
2.
Check whether door is over flush or under flush. If it is over flush move the striker towards
vehicle centre and check flushness. If it is under flush move the striker away from vehicle
centre and check flushness.
3.
After above corrections are done tighten the striker mounting bolts with torque value
25
N-m to 30 N-m
Door Setting - For Back door
:
Refer photos shown.
1.
Open the door and while closing it check whether striker is at the centre of latch. If it is
not at the centre of latch, striker will foul with top or bottom portion of latch or dovetail.
Loosen the bolts of striker and move the striker up or down to remove the fouling.
Similarly loosen the bolts of dovetail and move the dovetail up or down to remove the
fouling.
2.
Check whether door is over flush or under flush. If it is over flush move the striker towards
vehicle centre and check flushness. . If it is under flush move the striker away from vehicle
centre and check flushness.
3.
After above corrections are done tighten the striker mounting bolts with torque value
25
N-m to 30 N-m
Page 61
