Mahindra eMax 22L HST, Руководство оператора

Страница: 22 / 92

■
Operating the tractor
1. Before starting the tractor apply the parking brake, place the PTO (Power Take Off) switch in the
“OFF” position, the hydraulic control levers in the neutral position, the remote control valve
levers in the neutral position( if fitted) and the transmission in neutral.
2. Do not start the engine or controls while standing beside the tractor.
Always sit in the tractor seat when the engine is running or when operating controls.
3. Safety starter switch.
In order to prevent the accidental starting of the tractor, a safety switch has been provided.
The starting system of the tractor is connected through this switch, which becomes operative only
when the brake pedal is depressed.
On some models, the shuttle shifter lever and PTO button should also be in neutral position for
completing the starting circuit.
Do not bypass the safety starter switch .
Consult your Mahindra Tractor dealer/distributor if the safety- starting switch malfunctions.
4. Avoid accidental contact with the gear shifter lever while the engine is running.
Unexpected tractor movement can result from such contact.
5. Do not get off or climb around the tractor while it is in motion.
6. Shut off the engine, remove the key and apply the parking brake before getting off the tractor.
7. Do not operate the tractor in an enclosed building without adequate ventilation.
Exhaust fumes can cause death.
8. Do not park the tractor on a steep slope.
9. If power steering or the engine ceases to operate, stop the tractor immediately .
10. Pull only from the swinging draw bar or the lower link drawbar in the down position.
Use only a drawbar pin that locks in place.
Pulling from the tractor rear axle carriers or any point above the rear axle may cause the tractor’s
front end to lift.
11. If the front end of the tractor tends to rise when heavy implements are attached to the three-point
linkage, install front end or front wheel weights.
Do not operate the tractor with a light front end.
12. Always use the hydraulic position control lever when attaching equipment/implements and when
transporting equipment.
Be sure that the hydraulic couplers are properly mounted and will disconnect safely in case an
implement accidentally detaches.
13. Do not leave equipment/implements in the raised position.
14. Use the flasher/ Turn signal lights and Slow Moving Vehicle (SMV) signs when driving on public
roads during both day and night time, unless prohibited by law.
15. Dim tractor lights when meeting oncoming vehicles at night.
Be sure the lights are adjusted to prevent blinding oncoming vehicle operators.
16 .Emergency stopping instruction; If the tractor fails to stop even after application of brakes.
turn off the ignition switch. (or turn off the key).
20