Mahindra AX AC 4S ST, Руководство пользователя, Страница: 253 / 337

14-26
© Copyright Mahindra and Mahindra Ltd. 112020
between Four different modes depending on the torque
requirement.
• 2H (Two wheel drive high)
• 4H (Four wheel drive high)
• N (Neutral)
• 4L (Four wheel drive low)
Transfer Case is a part time manual shift system. There is no synchronizer
in transfer case and hence Shifting while the front or rear axles rotating at
different speeds can cause damage to the transfer case.
Vehicle is equipped with electric front axle disconnect (FAD). There may be
a slight delay and ratcheting noise while FAD is engaging as the splines
may not be aligned. This is normal.
Proper operation of four-wheel drive vehicles depends on tires of equal size,
type, and circumference on each wheel. Any difference will adversely affect
shifting and cause damage to the transfer case.
1 14 4..1 11 1..1 1 O Op pe erra attiin ng g IIn nssttrru uc cttiio on nss/ /P Prre ec ca au uttiio on nss
Transfer case provides four mode positions;
2 2H H,, 4 4H H,, N N a an nd d 4 4L L..
2 2H H::
Only the rear wheels are driven at 1:1 speed ratio. Use this
mode for normal driving on normal street, dry hard-surfaced roads
& highway conditions. This position gives greater fuel economy,
quietest ride and least tire wear.
4 4H H::
All four wheels are driven at 1:1 speed ratio. This mode
provides additional traction and maximum pulling power for loose,
slippery road surfaces such as ice, snow, gravel, sand and dry
pavement. Front and rear axles are locked together in this mode
which forces the front and rear wheels to rotate at the same
speed.
N N:: ::
Used only for towing in case of flat tyres or breakdown. (Vehicle
equipped with automatic transmission to be towed strictly in N
mode of transfer case)
Accidents may happen if you leave the vehicle unattended with
the transfer case in the NEUTRAL (N) position without first fully
engaging the parking brake. The transfer case NEUTRAL (N)
position disengages both the front and rear axle from the
powertrain, and will allow the vehicle to roll, even if the
automatic transmission is in PARK (or manual transmission is
in gear). The parking brake should always be applied when the
driver is not in the vehicle.
4 4L L::
Use this mode for maximum pulling power and traction. Use the
4L position for climbing or descending steep hills, off-road driving,
hard pulling in sand, mud or deep snow. Driving in the 4L position
on dry hard surfaced roads may cause increased tire wear and
damage to driveline components. Take care not to over rev the
engine and do not exceed 40 kmph when driving in this mode.
When operating your vehicle in 4L, the engine speed is considerably
S ST TA AR RT TIIN NG G A AN ND D D DR RIIV VIIN NG G T TH HE E V VE EH HIIC CL LE E