Mahindra 3535, Руководство оператора

Страница: 72 / 108

35 Series-HST, Model - 3535, 4035, 4535 & 5035
71
Oil Level Check
Check engine oil before starting the engine.
1. Remove dipstick gauge (A) provided on the left hand
side of the crankcase.
2. Oil level should be between the two marks provided on
the dipstick (A).
Oil Change
Change engine oil as per Routine Service Schedule Chart
given in this manual.
1. Ensure that the engine is stopped before changing oil.
2. Remove the drain plug (C) provided at bottom of oil
sump.
3. Allow the oil to drain at least for five minutes. All the
oil can be drained out when engine is still warm.
4. Now reinstall the drain plug. Service the oil filter as
explained below.
5. Remove the breather cum oil filler cap (B) to expose the
oil filler neck.
6. Refill the oil sump slowly by recommended grade of oil
(15W40) from the oil filler neck.
7. Clean and place the breather again.
Engine Oil Filter
The life of engine depends upon clean oil being circulated
to its bearings. In the normal course of engine operation
the lubricating oil undergoes changes which produce
harmful by-products. The purpose of the oil filter is to
separate and remove dirt and other injurious foreign
materials from the oil and prevent these from being
circulated in the engine.
The oil filter (D) should be replaced as per Routine Service
Schedule Chart given in this manual or whenever engine oil
is changed.
Changing Spin On Filter
1. Ensure that engine is stopped before changing filter.
2. Unscrew the oil filter (D).
3. Prime the new spin-on filter with clean oil.
4. Screw the new filter to the adapter.
5. Move the Hand and foot throttle to engine “Idle”
position.
6. Start the engine, check the oil pressure gauge to see
whether the lubricating oil is circulating through the
Engine.
7. Inspect the oil filter (D) for oil leaks.
Note : Stop the engine immediately if Oil pressure is not
recorded within 10 seconds of engine starting or Leakage is
observed. Get the cause identified and rectified before
proceeding further.
Note : Engine oil and filter element must be
changed after initial 100 hrs. of operation in
new tractor or whenever major overhaul of
engine is carried out and subsequently after
every 200 hrs. respectively.
To avoid delays, we recommend that you carry
extra filter elements on hand so that
replacements can be made at the correct time.
The FILTER is located on the right-hand side of
the crankcase.
Filling oil consumes time. Allow sufficient time
for the oil to settle down in crankcase.
Lubrication System
A
C C
B
D