Mahindra 3535, Руководство оператора

Страница: 44 / 108

35 Series-HST, Model - 3535, 4035, 4535 & 5035
43
Brake
Two independent brake pedals are provided on left side of
the operator for LH and RH wheel braking to enable sharp
turns during field operations.
To make a sharp turn to the left, depress LH brake pedal
(A).
To make a sharp turn to the right, depress RH brake
pedal (B).
The brakes can be latched together to act simultaneously by
means of brake pedal latch (C) as follows,
1. Rotate brake pedal latch (C) clockwise until it locks into
RH brake pedal (B).
2. When brakes are applied with brake pedals latched
together, the tractor should stop in a straight line.
Check and adjust brake settings if the tractor is dragged
to either side on applying brakes.
The Hand Throttle Lever should be brought to low idle rpm
position before applying brakes.
Using unlocked brakes to stop the tractor at high
speeds may cause accidental turning or tipping.
Lock pedals together when not using the turn brakes or
for road travel.
Slow down before making a turn.
Do not apply independent brakes while an attachment
is engaged with the ground. This can cause damage to
the attachment , three point linkage of tractor and may
also result in tipping of the tractor.
The brake pedals for this tractor are provided on the LH
side. While getting down from the tractor LH side, after
applying parking brake, get down slowly and ensure
that the brake pedal do not get pressed and
disengaged the parking brake. When parking on a
slope, ensure that the vehicle is parked across the slope.
To avoid personal injury :
Before dismounting the tractor,
Always apply the parking brake and lower all
implements to the ground. Leaving the
transmission in gear with engine stopped will
not prevent the tractor from rolling.
Controls
Parking brake
The Parking brake lever is provided in front of operator’s
seat.
Locking :
1. Lock both brake pedals together by using latch.
2. Press the brake pedals by foot.
3. Pull park brake lever completely upwards to the lock
position and hold it.
4. Remove foot from the brake pedals. Both pedals should
now stay depressed in locked position.
5. Parking brake indicator lamp will glow when key switch
is 'ON'.
Unlocking :
1. Press the brake pedals with foot.
2. The park brake lever will spring back to unlock position.
3. Remove foot from the brake pedals. Both pedals should
now be released from the lock position.
Always ensure to unlock parking brake before driving the
tractor. Check for indicator lamp on the instrument cluster
when the parking brake is released. The indicator light
should be 'OFF'.
Brakes Latched
A
Unlatched
B
C