MAHA Powerdyno MSR 400, Оригинальная инструкция по эксплуатации

Страница: 8 / 103

8
BA053401-en
1.5 Safety Instructions for Operation

The dynamometer shall be used and operated exclusively for its intended purpose and only
within its performance limits.

The dynamometer shall only be operated by trained personnel. Dynamometer and working area
must be kept clean.

The dynamometer shall only be operated by persons who are physically and mentally fit. These
persons shall be well rested and not under the influence of alcohol, drugs or medication.

When not in use the system must be switched off and the main switch protected against re-
start.

No persons shall be in the danger zone of the dynamometer. Rotating or moving parts are dan-
gerous.

Pay close attention to accident prevention regulations.

Never climb on roller sets even when locked.

Avoid unnecessary strain on vehicle and dynamometer. Drive the vehicle slowly onto the dyna-
mometer.

Regularly check the tightness of the cover plate attachment screws.

No persons shall be in the pit with dynamometers in conjunction with a working pit while a vehi-
cle with rotating wheels is on the roller set.

Wear personal protective clothing. If necessary wear protective goggles. Particles ejected from
rotating vehicle wheels can cause severe injuries. Wear tightly fitting working clothes and bind
long hair together. Clothing or hair can get caught and pulled into machinery.

Danger of hearing damage due to high noise level! Use hearing protection approved up to
120 dB(A). Noise levels over 110 dB(A) can be reached during vehicle testing. The operator is
responsible for determining the noise level in vehicle and test room. When necessary, wear
suitable hearing protection. The operator must attach warning stickers.

Danger of carbon monoxide poisoning by poisonous vehicle exhaust. The dynamometer shall
only be operated if the room and working pit in which it is installed have sufficient exhaust suc-
tion and ventilation including the appropriate warning system.

Avoid steering movements during the vehicle test. These cause certain forces to act on the ve-
hicle fixing, in particular on the attachment units on the test vehicle.

Before exiting the vehicle, put the gear into idle. If necessary decelerate the vehicle in a con-
trolled manner avoiding steering movements. Wait until vehicle and rollers have stopped moving
before exiting the vehicle. Danger of body parts and clothing being pulled into rotating rollers
and vehicle wheels.

Keep the dyno surface clean and dry. Danger of slipping when surface is wet, oily or icy! Do not
place any objects (tools, material etc.) on the dynamometer. Wear protective shoes with anti-
slip soles and steel toe caps to avoid slipping and mechanical injuries. Parts which protrude
more than 20 mm out of the floor are to be marked with black-yellow tape.

In addition to the danger zone, the operator is responsible for confining the area of the test
room in which no persons are allowed during testing with a safety catch device or a cell wall.
Mark the danger zone (roller width + 1100 mm) on both sides behind the vehicle up to cell
wall/safety catch device.

Danger of accident due to vehicle fixing fracturing! Do a visual check for damage to the vehicle
fixing before each use. Never start the test operation without suitable and correctly installed ve-
hicle fixing.