MAHA Powerdyno MSR 400, Оригинальная инструкция по эксплуатации

Страница: 50 / 103

50
BA053401-en
8 Preparations for Testing
8.1 Switch on the Dyno
1 Switch on the main switch at the communication desk.
2 Push the Control ON button.
See also section "Description / Controls and Indicators".
8.2 Drive onto Dyno
Risk of injury by flying particles!

Before driving onto the rollers, remove all particles such as gravel etc. from the tires.

Check the balancing weights on the rims for tight fit.

Wear protective glasses.
1 Drive the vehicle slowly and straight onto the dyno and position the vehicle in the center.
2 Place the gear in idle or to position NEUTRAL with automatic vehicles and release the
emergency brake.
3 Place the wheels of the front axle straight on in driving direction. The steering wheel lock may
not be locked!
8.3 Fix Vehicle
Life-threatening injuries possible if vehicle breaks loose from fixing!

No persons shall be in the test room during vehicle testing! Danger!

Fix the test vehicle before each test with the proper (MAHA-) vehicle fixing. Usage of a different
fixing attachment can affect safety and cause personal injury. MAHA accepts no liability for the
resulting damage.

The vehicle must be fixed in such a way that the vehicle cannot laterally break away and that no
swinging movements are created!

Safeguard that the vehicle mass cannot be moved on the rollers!

Make sure that the vehicle fixing is suitable for the vehicle being tested.

Only skilled, trained personnel shall install the vehicle fixing.

Always install the vehicle fixing completely and properly and check its proper functioning before
test start.

Check the orderly condition and suitable rigidity of the vehicle’s attachment unit before every
vehicle fixing procedure!

If using tightening straps, fasten them to suitable parts of the chassis. Pay close attention that
the loose ends do not get close to the tires or rollers. This is especially important when the fan
is switched on!