MAHA Powerdyno MSR 400, Оригинальная инструкция по эксплуатации

Страница: 7 / 103

7
BA053401-en
1 Safety
1.1 Introduction
Thoroughly read this manual before operating the equipment and comply with the instructions.
Always display the manual in a conspicuous location.
Personal injury and property damage incurred due to non-compliance with these safety
instructions are not covered by the product liability regulations.
1.2 Symbols
Important safety instructions. Failure to comply with instructions could result in personal injury or
property damage.
Important information.
1.3 Intended Use
This dynamometer is to be used exclusively for the performance testing of motor vehicles. It is not
suitable for brake testing or noise detection. Observe the rated axle load.
The equipment may not be modified without the express written consent of the manufacturer. In
case of non-compliance the declaration of conformity becomes void.
Any use other than described is inappropriate.
1.4 Safety Instructions for Commissioning

Only authorized service technicians may install and commission the test stand.

The test stand may not be installed and operated in fire-endangered operation facilities, outside
or in damp rooms (e.g. wash halls).

Mount components of the vehicle fixing unit in advance on a suitable lift on the test stand.

Warning stickers must be attached by the operator:
– Hearing damage due to high noise level. Wear hearing protection.
– Severe eye injuries due to flying particles. Wear protective goggles! Operator is responsible.

Wear personal protective clothing as required or as regulated by law. The personal protective
clothing must meet the safety-technical regulations for the respective work application.