4
BA551101-en
Pos: 13 / Technische Dokumentation/Alle Geräte/Überschriften/ Überschriften 1.1/S/Überschrift 1.1: S icherheitsvorschr iften für den Betrieb @ 6\m od_1174482268953_ 75.docx @ 76826 @ 2 @ 1
1.5
Safety Instructions for Operation
Pos: 14 / Technische Dokumentation/Hebetechnik/PITFORCE/551101 A B / A BA / ABT / AT-N B / A TV / SA T/BA/Inhalt: 5511 Sicherheitsvorschriften für den Betr ieb LAM @ 29\m od_1339747293146_ 75.docx @ 1608268 @ @ 1
•
Transportation only by trained personnel and with a suitable tool.
•
Observe notes with regard to possible dangers during mounting or ensuring
correct handling.
•
shall only be carried out by authorised personnel.
•
Mounting, commissioning, adjusting, operating, maintenance, repairs and de-
mounting shall only be carried out by trained and authorised personnel.
•
In the event that a person is not strong enough to operate the device manually,
a suitable tool or another person should be called upon.
•
The operator is responsible for ensuring that the user is instructed and familiar
with the operating instructions.
•
The maximum permissible positioning speed of the load-carrying equipment is
0.01 m/s. Only operation by hand is allowed.
•
The maximum permissible load depositing speed is 0.1 m/s.
•
During the positioning of the actuators, no limbs shall be in the hazard area.
•
Load-carrying equipment, actuator and accessory kit shall be tested before use
for operational safety. The load-carrying equipment shall only be operated in a
safe and slip-resistant state.
•
Actuators should be protected from falling with suitable protection parts. Oper-
ation is not permitted until missing or defective protection parts are implement-
ed according to the replacement parts list.
•
The load bearing capacity specified on the name plate must not be exceeded.
•
The load centre shall only be centrically carried.
•
During operation when the load is in an unsecured condition, no-one must be in
the hazard area.
•
Before depositing, the operator must ensure that no objects are located in load
movement area which could prevent a safe support.
•
After the end of operation and before each transportation, all assembly parts
must be removed from the load-carrying system and stored in a suitable place.
•
The markings and notes on the device shall be checked regularly for readability
for the entire life span and, if necessary, replaced according to the replacement
parts list.
•
Maintenance and repairs shall be carried out according to the manufacturer's
stipulations by an expert.
Pos: 15 /----- Format-----/MAN UELLER UM BRUCH Seitenumbruch @ 0\m od_1134403577687_ 0.docx @ 1277 @ @ 1
