7
BA082201-en
1.6
Safety Instructions for Commissioning
WARNING
The axle jack must be installed and commissioned by authorized service per-
sonnel only.
The axle jack must be installed only with a suitable running gear on level, stable
and parallel guide rails or working pits. It must be secured against falling out
and derailment.
The standard axle jack version must not be installed and commissioned in the
vicinity of explosives or flammable liquids, outdoors or in moist rooms (e.g. car
wash).
1.7
Safety Instructions for Operation
WARNING
Read the detailed operating instructions.
Lift operation by trained personnel over 18 years only.
The load capacity of the axle jack must not exceed 2/3 of the lift load capacity.
Ensure an unobstructed movement of the axle jack.
After raising the vehicle briefly, stop and check the supports for secure contact.
Make sure the vehicle doors are closed during raising and lowering cycles.
Closely watch axle jack and vehicle during raising and lowering cycles.
Before each lifting procedure, check whether the running gear of the axle jack is
correctly placed.
It is the operator’s responsibility to make sure that operation represents no
danger to persons.
The axle jack is to be used as lifting device only. Never transport the load using
the axle jack.
Before working on the vehicle, lower the axle jack to nearest safety notch.
When lifting a vehicle with two axle jack units, they must have a minimum sepa-
ration of 0.85 m.
Do not allow anyone to stay in lift area during raising and lowering cycles.
Do not allow anyone to climb on the raised vehicle.
Comply with the applicable accident prevention regulations.
Do not exceed the rated load capacity as indicated on the type nameplate.
Only use the vehicle manufacturer's recommended lift points.
Do not use the lift for transporting persons.
Keep the axle jack and the working area clean.
