MAGUIRE LPD-30, Установка, эксплуатация и обслуживание

Страница: 63 / 127

Maguire Products, Inc.
Edition: November 5, 2010
63
LPD Dryer
®
4 – Maintenance and Service
To help you identify your Dryer see: LPD Nomenclature / Order Code on page 90.
4.1 - Clean / Replace Air Filter
The air filter must be periodically cleaned or replaced.
Do not access filter while Dryer is running.
A clogged filter will result in a lower then usual heater on-time duty cycle and a
delay in reaching temperature.
The partially blocked, slower moving air cannot remove heat from the heating element
as effectively, and therefore the heater on time percentage is lower. A delay in
temperature rise will eventually result in an alarm. Your particular processing conditions
will determine how frequently this filter should be checked or cleaned.
The air filter is located inside the front door of the
Series 30 models and at the base of the left-side
panel on the Series 100 and 200 models. To access
the air filter, unlatch the filter door and slide the filter
out. Clean or replace filter as necessary.
To clean filter, knock any larger debris off the filter,
then blow compressed air through the filter from the
inside blowing out through the filter paper. With the
filter removed, clean out the box with a vacuum.
Filter location for Models 100, 200
(left side of Dryer)
Filter location for Model 30 (behind
front door)
The frequency of cleaning depends on the type of
material being processed and the number of hours
that the Dryer is run per shift.
Do not run the dryer without the proper filter
installed. Damage to the blower may result.