MAGUIRE LPD-30, Установка, эксплуатация и обслуживание

Страница: 57 / 127

Maguire Products, Inc.
Edition: November 5, 2010
57
LPD Dryer
®
ATS - Anticipated Temp – Sooner – seconds
DO NOT CHANGE THIS PARAMETER – ADVANCED MODE ONLY
This parameter specifies the “sooner” time forward, in seconds, to anticipate
temperature. It controls when temperature is climbing or falling too RAPIDLY. Higher
numbers cause more cautious corrections.
Lower Numbers allow logic to ramp up to temperature more quickly. If temperature
overshoots on initial ramp up, this number is too low.
ATL - Anticipated Temp – Later – seconds
DO NOT CHANGE THIS PARAMETER – ADVANCED MODE ONLY
This parameter specifies the “later” time forward, in seconds, to anticipate
temperature. This parameter controls when temperature is climbing or falling to
SLOWLY. Higher numbers cause more cautious corrections, useful to prevent
hunting once target has been reached, or nearly reached.
NCT - No change Temperature – 0.1 degrees
DO NOT CHANGE THIS PARAMETER – ADVANCED MODE ONLY
This prevents adjustments from occurring if BOTH the ATS and ATL temperatures are
within this limit, in 1/10 degree, of TARGET. Using the default setting (NCT 00005), if
both future temperatures calculated using ATS and ATL are within ½ (0.5) degrees of
Target, no adjustment occurs.
RCC - Rate of Correction Constant
DO NOT CHANGE THIS PARAMETER – ADVANCED MODE ONLY
Interacts with the adjustment amount math routine to fix the extent of correction that
an error causes. Lower numbers cause larger corrections, but may produce hunting.
Higher numbers produce smaller corrections, and are safer, but slow correction
response time. The number is used in a software algorithm to calculate corrections.
Call us if you want to know exactly how it works. We have to leave our competitors
something to figure out on their own. If hunting above and below target occurs
continuously, raise this number.
MAX - Maximum Temperature - F degrees
This number is the maximum temperature limit that the Dryer will run up to. Any
temperature setting on the Temperature thumbwheel, above this number will be limited
to this maximum temperature. If the thumbwheel is set to a temperature above this
MAX setting, the “TARGET TEMP TOO HIGH” alarm activates.
CFA - Convey Failure Alarm - sec / tries - ignore sensor flag
If a convey sequence does not result in the sensor being covered, this parameter
determines the time delay before the receiver will try again. It also sets how many tries
must occur before the alarm is activated. x05xx sets retry time to 5 seconds. xxx03
sets the number of tries before alarm to 3. For Convey Mode options see 39 in the
Star Functions section, page
37
.