MAGUIRE LPD-30, Установка, эксплуатация и обслуживание

Страница: 10 / 127

Maguire Products, Inc.
Edition: November 5, 2010
10
LPD Dryer
®
2 - Installation
2.1 – Transport, Unpacking and Setup
To help you identify your Dryer see: LPD Nomenclature / Order Code on page 90.
Unpacking - Removing from Carton
Cut sides and top flaps, unscrew screws and washers from the sides at the skid.
There are 6 screw locations. Remove carton, remove cardboard tray at the top
of the carton. On Series 30 models, cut and remove plastic wire ties from
handles inside the dryer attached to the black frame member. On the Series 100
and 200 models, remove the packing material from around the canisters and
brackets.
Return Shipping Information
Save the carton and cardboard if at all possible, reuse for return to
factory. Use strong plastic wire ties to affix the canister from turning on
the Series 30 units. On the Series 100 and 200 models, it is advisable to
use packing material around the canister support brackets and ship the
canisters on a separate skid or carton.
Lifting
DANGER OF INJURY!
If the weight is unevenly distributed, the Dryer may tip and injure
people when it is lifted.
Lift the Dryer with a fork truck or suitable equipment. Weights of
Dryer models range from 425 pounds (193 Kg) to 900 pounds (408
Kg). Lift points are between the wheels, oriented from front or rear.
The forks must be closest to the inside of the wheels as possible for
stability.
Remove Skid
To remove the skid, unbolt the two bolts that secure the
dryer to the skid.
The bolts are located at the bottom of the Dryer and go
through the wooden skid. These bolts can be loosened
while the Dryer and the skid are on the ground. Reverse
procedure to install dryer on the skid.