4 - Installation
Dynamag Duo| Secure Card Reader Authenticator | Installation and Operation Manual
Page 16 of 23 (
D998200203-10
)
4.4
How to Mount Dynamag Duo
Dynamag Duo is designed and tested to operate as a surface-mounted device. It can be mounted in
various ways:
Using two screws through the surface attached to the bottom of the device, drilling a hole in the
surface for the cable, and running the cable through the hole. Mounting may or may not include
washers or a gasket, depending on solution requirements.
Using fastening tape on the surface and running the cable on the top of the surface.
Mounted to a custom, solution-specific mounting plate on the surface. The custom plate may or may
not include a gasket, washers, or other hardware, depending on solution requirements.
Screw mounting requires 2 ea.
M3.5
metric screws. The length of the screws depends on the solution
design, including the thickness of the mounting surface and any washers or gaskets.
To mount the device with fastening tape:
1)
Thoroughly clean the installation surface with isopropyl alcohol.
2)
Remove the adhesive protective cover on the fastening tape
3)
Position the device carefully
4)
Push the device down firmly, then move gently back and forth while pressing down to fully seat the
adhesive.
Further details about creating mount designs are provided in section
