Magnum V-BOX PV Series, Инструкция по установке и эксплуатации

Страница: 11 / 48

11
1. Electric Throttle Control Panel Switch Functions (Optional)
(Sequence of Operations)
Electric Throttle Control Panel Switch Functions Cont.
A. ON/OFF System power activated (ready to start). Spreader engine is not running.
Spreader conveyor is not engaged.
B. START (Engine only)
1. Open fuel shut off valve on engine.
2. On On switch depressed.
3. Choke (cold engine ) Hold down for 5 seconds to move the throttle actuator to
the choke position.
Note: Choking a warm engine may not be necessary.
4. Start Hold down until engine starts.
4a. On models with 6.5 HP at temperatures under minus 20
o
F (minus 29
o
C) it may be
necessary to start the engine manually.
5. Turtle Deceases throttle speed - adjust as engine warms up. Will stop the choke function.
Rabbit Increases throttle speed.
C. TO ENGAGE Spreader Conveyor
1. Push CONVEYOR switch only after you are sure no one is in the hopper or near the spinner! This lights up
the red indicator light, if light does not light, take care to verify that the light is not malfunctioning.
D. TO CONTROL Conveyor Speed.
1. Hold RABBIT to increase speed. NOTE: Do not hold switch in HI position after the desired RPM is achieved
or you will choke and/or stall the engine.
2. Hold TURTLE to decrease speed.
WARNING
SPREADER OPERATION
Electric Throttle Control Panel Switch Functions (Optional)
(Sequence of Operations)