Magnum V-BOX PV Series, Инструкция по установке и эксплуатации

Страница: 12 / 48

12
1. As with all power equipment, safety is the number one concern.
2. Do not operate this equipment until you fully understand how it functions.
3. Before starting engine, be sure that no one is near the rear of the unit and that no one is inside the
unit!
4. Do not start the engine or engage the conveyor (which is interconnected to the spinner); until everyone
is clear from moving parts and flying material from the spinner.
E. TO DISENGAGE Spreader Conveyor.
1. Tap START switch momentarily so that red indicator light goes out. Do not fully depress the START switch,
only half way is needed. Only the conveyor stops, the engine continues to run.
F. TO TURN ENGINE OFF (with or without conveyor running).
1. Depress LO on throttle control to reduce setting to idle (this prevents engine flooding and hard starting).
2. Push OFF position on the ON/OFF switch.
NOTE: OFF can be pushed at anytime during spreader operation to cut power to the unit . However, you
should normally use steps under F above.
(Once the off switch is depressed - the starting procedure must be followed for engine re-start.)
G. Do not attempt to start the engine with the conveyor engaged. (CONV switch light will be lit to indicating its'
being on.)
H. Close fuel shutoff valve on engine if unit is to be transported while not running.
WARNING
SPREADER OPERATION