Magnum MIG200L PRO DUAL PULSE, Руководство по эксплуатации

Страница: 8 / 30

OPERATION MANUAL
6
MIG INSTALLATION
1.Connect the welding torch into the Euro MIG torch connection socket on the front panel, and tighten it.
2.Insert the earth cable plug into the required polarity and tighten -negative for gas shielded wires positive for
gas less wires. + postive for gas wire. The weld power cable goes into the opposing negative or positive
socket.
3.Connect Gas Line to Gas Regulator and connect the gas regulator to the Gas Cylinder. Carefully open the
valve of the gas cylinder, set the flow to 5 l/min.
4.Fit the correct type and size of drive rollers (see the chapter of wire feed roller selection)
5.Place the Wire Spool onto the Spool Holder. Feed the wire into the wire feeder inlet guide tube through to
the drive roller.
6.At the wire feed assembly, release the compression screw by swivelling it outwards. This allows the top
roller arm to spring to the open position.The end of the welding wire can now be passed through the inlet
guide, over the bottom driven roller, and into the output wire guide tube.
7.Check that the drive roll groove is correct for the wire in use. The appropriate size is stamped on the visible
side of the installed roller. Check also that the correct size contact tip is fitted at the gun end.
8.Return the top roller arm to the closed position and adjust the compression screw to provide sufficient
clamping of the drive roll to achieve constant wire feeding. Do not over tighten.
9.With the equipment energised, operate the gun switch to feed wire through the gun cable.