Magnum MIG200L PRO DUAL PULSE, Руководство по эксплуатации

Страница: 28 / 30

MIG 200L PRO DUAL PULSE
26
MAINTENANCE
Regularly remove dust with clean, compressed air. If the welding machine is working in smoky conditions, in
heavily polluted air, remove accumulated dust daily.
The compressed air pressure should be maintained at such a level as not to damage small parts inside the
device max. 2-4 bar.
Regularly check the internal systems of the welder, check the correctness and reliability of connections
(especially equipment and parts). If you notice rust and loose the connection, remove the rust or oxide
coating with sandpaper, reconnect and tighten.
Avoid situations where water or steam can enter the device. If the welder gets wet, dry it and then check the
insulation of the device (also between joints and contacts). After checking that everything is OK, you can
continue working.
SET CONTAINS:
I. Gas shielded welding gun Binzel MB24 3 meters
2.1 set earth clamp (3 meters);
3.4 meter MMA holder(torch)
4.0.8/0.9V roller; 1.0/1.2U roller; 0.8/0.9 Knurled roller
5. 3 meter gas tube
6.Carbon Liner installed inside, Aluminum Liner place with accessories.
7. 10pcs 0.9mm tips
8.10pcs 1.0mm tips
9. 2 pcs hose clamp