Magnum Industrial MI-92300, Руководство по эксплуатации

Страница: 12 / 22

-11-
Cut the measuring tape between both zeros A .
Remove the backing strip from the first half of
the measuring tape (the one with the zero on the
left) and carefully install along the rail slot, using
your pencil mark as the zero-point of the tape .
Trim off excess tape B wih a knife or scissors.
Reinstall the fence on the front rail and lock
it down. Then, reinstall the pointer (place
the screw in the middle of the hole to allow
maximum adjustment capacity on the left or right
afterward), and slide the pointer right or left, so
that its center mark is in line with the zero-point
of the tape. Tighten the screw to lock the pointer
in place.
Unlock the guide fence and repeat steps 1 to 5
with the fence to the left of the blade this time,
aligning the center mark of the left pointer with
the zero of the second half of the measuring
tape.
VERTICAL ADJUSTMENT OF THE FENCE 90° TO THE TABLE
Place a machinist square on the table against
the fence (See Step 4 below) and, either by eye
or with a feeler gauge, look for a gap between
the square and the fence (bottom and top) or the
table. If needed, adjust as follows.
With a 5 mm Allen key, loosen the set screw
(without removing it).
Put the fence back on the rails, but do not
engage the locking handle to lock the fence.