Magnum Industrial MI-52100, Руководство по эксплуатации

Страница: 10 / 13

9
ADJUSTING THE ASSEMBLY
MAGNUM INDUSTRIAL MI-52100 10" OVERARM BLADE GUARD
ADJUSTING THE BLADE GUARD ASSEMBLY
You can adjust the resistance or balance of the swing arm
assembly by turning the
SPRING KNOB (A) located at the rear
of the swing arm assembly. See Figure 27.
You can lock the hood in any position by tightening the HOOD
LOCK HANDLE (B) located at the right side of the hood. See
Figure 27.
It's best to lock the hood in the upper position when removing
or swinging the boom and hood assembly from the saw.
Adjust the length of the telescoping boom by loosening the
BOOM CLAMP KNOB (C) and sliding the inner boom in or out
as required. See Figure 28.
Do not over-tighten the clamp knob. It takes only a little
pressure to clamp the boom securely.
Adjust the bottom lock knob on the boom mount channel by
loosening the
LOCK NUT (D) on the threaded lock pin and turn
the handle in the desired direction to tighten or loosen the
lock. The pin needs to swing just past centre to lock properly.
See Figure 29.
To remove the boom assembly from the saw, release the lock
pin, swing the boom assembly back and lift it off the pivot pins.
See Figures 30 and 31.
ADJUSTING THE PARALLEL BOOM
Move the HEX HEAD STOP BOLT (E) in or out as needed to
align the boom so it's parallel to the front and back edges of
the saw. When the boom is aligned, tighten the
NUT (F) to
secure the bolt. See Figure 32.
CONNECTING TO A DUST COLLECTOR
Before starting the table saw, connect to a dust collection
system. Connect a 4" dust hose (not included) from your dust
collector to the bottom of the boom assembly. See Figure 33.
Check that all connections are sealed tightly to minimize
airborne dust. Always turn on the dust collector before starting
the table saw and always stop the table saw before turning off
the dust collector.
FIGURES 27 and 28: ADJUSTING THE BLADE GUARD AND BOOM
28 27
FIGURE 29: ADJUSTING THE BOTTOM LOCK KNOB
30
29
FIGURES 30 and 31: REMOVING THE BOOM ASSEMBLY
FIGURE 32: ADJUSTING THE BOOM ASSEMBLY
FIGURE 33: CONNECTING A DUST COLLECTOR HOSE
31
32 33