Magnum Industrial MI-52100, Руководство по эксплуатации

Страница: 9 / 13

8
ASSEMBLY INSTRUCTIONS
MAGNUM INDUSTRIAL MI-52100 10" OVERARM BLADE GUARD
ATTACHING THE BOOM TO THE
BOOM MOUNT CHANNEL
1. Place the boom and hood assembly on the pivot pins
located on the boom mount channel. See Figures 19
and 20. Swing the arm over the table.
2. Secure the locking pin to hold the boom in position.
See Figures 21 and 22.
3. Loosen the BOOM CLAMP LOCK KNOB (A) and
extend the boom to position the hood assembly over
the blade. See Figure 23
4. Lower the hood assembly over the blade. See Figure
23. Then adjust the boom mount channel position to
roughly centre the hood assembly over the blade.
5. Tighten the mounting bolts and secure the boom
mount channel in position on the extension table.
See Figures 24 and 25.
6. If you notice sag or if the extension table is not level
with the main table, adjust the height of the support
leg to support the added weight of the boom/hood
assembly. See inset of Figure 26.
7. You can adjust the diagonal braces. Tighten or loosen
the nuts on the eyebolts as needed to level the boom
assembly. See Figure 26.
FIGURES 19 and 20: ATTACHING THE BOOM
19 20
FIGURES 21 and 22: SECURING THE BOOM
21 22
FIGURE 23: POSITIONING THE BOOM
23
FIGURES 24 and 25: POSITIONING THE BOOM
24
FIGURE 26: ADJUSTING THE BRACES
25 26