©
2010 Magnum Energy, Inc
Page 43
Operation
3.6 Protection Circuitry Operation
The inverter is protected against fault conditions, and in normal usage it will be rare to see any.
However, if a condition occurs that is outside the inverter’s normal operating parameters, it will
shut down and attempt to protect itself, the battery bank, and your AC loads. If there is a condition
that causes the inverter to shut down, it may be one of the following conditions [also refer to the
Troubleshooting section (Section 4.3) to help diagnose and clear the fault condition]:
Low Battery
- The inverter will shut off whenever the battery voltage falls to the Low
Battery Cut Out (
LBCO
) level to protect the batteries from being over-discharged. After the
inverter has reached the LBCO level and turned off, the inverter will automatically restart
after one of the following conditions:
AC Power is applied and the inverter begins operating as a battery charger, or
Battery voltage rises to the Low Battery Cut In (
LBCI
) level
The inverter’s status LED turns off when a low battery fault condition occurs. Refer to Table
3-1 to determine the LBCO and LBCI levels for your inverter model.
High Battery
- In the event the battery voltage approaches the High Battery Cut Out
(
HBCO
) level, the inverter will automatically shut down to prevent the inverter from
supplying unregulated AC output voltage. The inverter’s status LED turns off when a high
battery fault condition occurs. The inverter will automatically restart when the battery falls
to the High Battery Cut In (
HBCI
) level. Refer to Table 3-1 to determine the HBCO and
HBCI levels for your inverter model.
Info:
High battery voltage may be caused by excessive or unregulated voltage
from the solar panels or other external charging sources.
Overload
- During inverter and standby operation, the inverter monitors current levels.
In the event of a short-circuit or an overload condition for more than a few seconds, the
inverter will shut down. To start operating after this fault, the inverter would need to be
restarted (turned back on) after the inverter’s AC loads are reduced/removed.
Over-temperature
-
If internal power components begin to exceed their safe operating
temperature level, the inverter will shut down to protect itself from damage. The inverter’s
status LED turns OFF to indicate the over-temperature fault condition. The inverter will
automatically restart after the units cool down.
Internal Fault
- The inverter continually monitors several internal components and
the processor communications. If a condition occurs that does not allow proper internal
operation, the inverter will shut down to protect itself and the connected loads. The
inverter will need to be reset to start operating again (refer to Section 4.4 for information
on resetting the inverter).
Table 3-1, Inverter Battery Turn On/Off Levels
Inverter battery turn
ON/OFF Levels
Inverter Model
ME2000/ME2012
ME2512
ME3112
HBCO
>15.8 VDC
>15.8 VDC
>15.8 VDC
HBCI
15.5 VDC
15.5 VDC
15.5 VDC
LBCI
≥
12.5 VDC
≥
12.5 VDC
≥
12.5 VDC
LBCO*
(1 minute delay)
10.0 VDC
(9.0 - 12.2 VDC)
10.0 VDC
(9.0 - 12.2 VDC)
10.0 VDC
(9.0 - 12.2 VDC)
LBCO (immediate)
8.5 VDC
8.5 VDC
8.5 VDC
*adjustable with remote control
•
—
—
•
•
•
•
