© 2016 Sensata Technologies
6
Installation
2.2
Required Materials/Tools (not included)
To properly install the AGS, you need to supply the following:
Required Materials
• #16 to #12 AWG (1.31 to 3.31 mm
2
) wire for connecting the
AGS to the generator start/stop circuit and to the battery bank
• In-line fuse holders (with a 5-amp DC fuse)
Required Tools
• Phillips screwdriver (#2)
• DC voltmeter
• Drill
• Flat-blade (1/8”) screwdriver • Cut-out tool
• Pencil
• Drill bits (7/64” & 1/8”)
2.3 Mounting
Procedure
Select an inside mounting location that is clean, dry, and protected
from extreme temperatures. Figure 2-2 shows the AGS’s dimensions.
Remove the 8-port terminal block from the AGS (Figure 1-1, Item
3). Remove the terminal by pulling it straight out.
Info: The AGS controller can be mounted in any direction. Be
sure to allow ample room to access the 8-port terminal block,
and the NETWORK and REMOTE connection ports.
Note: Do not plug the terminal block back into the AGS controller until
the installation is complete and you are ready to perform the functional
operation tests (see directions in Section 4.0).
• Mount the AGS using the four supplied #8 x 3/4” screws.
1
4
1 "
3
16
"
2"
(5
0.8
m
m
)
2
"
(7
0.5
m
m
)
3
4
3
8
"
(9.8 mm)
~
3
8
"
(9.8 mm)
~
4
"
(106.4 mm)
16
3
4
"
(124.5 mm)
8
7
~
(4.1 mm)
5
"
(137.2 mm)
8
3
(31.7 mm)
3
"
(8
2.5
m
m
)
3
"
(9
0.5
m
m
)
4 1
16 9
Figure 2-2, AGS-N Dimensions