Magnetic MHTM FlowMotion, Руководство пользователя

Страница: 64 / 80

64
Control unit MGC
Corrective action
Error messages "ERROR"
Faults that cannot be reset by the control unit are displayed as errors. The
pedestrian gate is put out of service.
If the function "Error" has been chosen for an output, this output is
deactivated at pending errors (fail safe).
The fault must be rectified and a reset carried out by a MHTM™ FlowMotion®
service expert so that the pedestrian gate can be put back into operation.
For the required qualification of the MHTM™ FlowMotion® service expert:
ä
Page 9, chapter 1.3.1.
IMPORTANT!
With some messages, the control unit tries to reset the cause of
the message. If the attempt was successful, the message is
displayed as WARNING. If the attempt failed, the message is
displayed as ERROR.
8.3.1 Event, warning and error messages – Logic control (control unit)
Number Designation Possible cause Corrective action
3120
ERROR Mains voltage
fluctuations
Short-term mains failure
has been recognised.
Check supply voltage and
mains quality.
5112
WARNING 24 V logic voltage too
low
Under voltage
›
Reduce load.
›
Check mains unit.
5530
ERROR EEPROM checksum Checksum of
parameters not correct.
›
Reset parameters to
factory settings.
ä
Page 56, chapter 6.9.
6000
ERROR Module update failed Firmware update was
not performed correctly.
›
Restart the control unit.
›
If the error continues to be
present, perform the
update again via the
service module.
6101
ERROR Software error: VS Software error
›
Perform software update.
6102
ERROR Software error:
System bus
Within the control, an
error is pending in
communication.
›
Check SW versions of all
plug-in modules. If
necessary, update via the
service module.
›
If all FW versions are up to
date, contact service.