Section 5 – Programming (Continued)
38
3.
Line up the PDA’s infrared port with the transmitter’s infrared port (remove battery door on the back and pull
battery pack back to expose the
tele
Pendant’s infrared port. See figure below:
tele
Pendant Infrared Port Access).
4.
From the application file’s main menu click on the PDA a dropdown menu icon located at bottom left corner or
tap on the word “Programmer” at the top of the screen. Select “Admin.”
5.
Under “Admin.” select “Send Setting.”
6.
Select a name you want for the
tele
Pendant unit being programmed and tap “OK”.
7.
Wait for confirmation text on PDA screen.
8.
After programming, always operationally test all the functions of the transmitter by using the appropriate receiver
with the MR relay disabled before retuning transmitter to service.
Receiving (Reading) the telePendant Programming.
To read a program file from the
tele
Pendant Transmitter:
1.
Line up the PDA’s infrared port and go to bank 5 as in steps 1 to 3 above, with the transmitter ON. Select
“Admin”
2.
Select “Receive Setting.”
3.
PDA will confirm reception and automatically display current programming in the
tele
Pendant unit.
Reading the telePendant ID.
To read an identity (an identity is the name that was programmed in by step 5 of Sending a Program To The
tele
Pendant,
listed above) from the
tele
Pendant Transmitter:
1.
Line up the PDA’s infrared port and go to bank 5 as in steps 1 to 3 above, with the transmitter ON. Select
“Admin”
2.
Select “Transmitter ID.”
3.
PDA will read: Name, Serial/Job Number, and Manufacturing information of the
tele
Pendant unit.
Name: ……………………………..…. M
Tx Type
2 SPD telePendant
Use bank password
Setting
Admin
Bank 1
on
Bank 2
off
Bank 3
on
Bank 4
off
Send Setting
Receive Setting
Beam Setting
Transmitter ID
History
About
First press Button 6
Second press Button 5
Third press Button 4
Fourth press Button 3
telePendant Infrared Port Access.
Battery pack