Section 5 – Programming (Continued)
31
N.
Main/Aux Menu for controlling the “Programmable Motor Control and Select Push Button”.
This menu shows only if no Special Crane Configurations are selected (Switch 3 positions 5-7).
This programming
redefines the function of the button just above the E-STOP.
(For a three motor crane use “Aux”, for standard four motor use “Motor ”, and for Select function use Select).
If replacing a Pendant transmitter: if Switch 4 on the Pendant transmitter has position 1 “OFF” and position 2 “ON” use
“Motor”; if Switch 4 has position 1 “ON” and position 2 “ON” use “Select”.
For a
three motor
system this Programmable Motor Control and Select push button is non-functional.
For a
four motor system
this button controls a main and aux motor such as a hoist (see Section 4. Operation for details on
the operation of this button). To program a fourth motion select “Motor”. This four motor application can only be used
with 4 motor crane configurations. The Programmable Motor Control and Select push button becomes a switch to toggle
between “A” and “B” or both, where “A” and “B” are main and auxiliary motors respectively. The main motor output is
motor 1 and the auxiliary motor output is motor 4.
For up to
5 motors
using the
select function
this button is available to use select relays. This select function can only be
used with five crane configurations. To program in the select function tap the word “Select”. The Programmable Motor
Control and Select push button becomes a switch to toggle between “A” and “B” or both, where “A” and “B” are Select 2
and Select 1 outputs respectively.
NOTE
THE “A” LED LIT CAUSES THE SELECT 2 RELAY TO CLOSE. THE “B” LED CAUSES THE SELECT 1 RELAY
TO CLOSE.
Tandem For Hoist, Trolley or Bridge (normally checked).
This function appears if a four motor system or select function is chosen. Normally the box is checked meaning “Both A
and B” operation is enabled (both MAIN and Aux or Select 2 and Select 1 can be ON at the same time). Removing the
check from the box by tapping on it disables the “Both” function (“A” and “B” will not come ON at the same time). This
function maps to Pendant Switch 4 position 3; if SW4 position 3 is switched “ON” un-check Tandem box on PDA.
Position 4 Invert Crane Select Aux. Outputs (normally not checked).
This function appears if a system using select is programmed in. Turning this switch “ON” inverts the select function
operation so that the relay closes for the unselected function. This function maps to Pendant Switch 4 position 4, if SW4
position 4 is switched “ON” check Invert box on PDA.
Crane control enabled
Tandem
Invert
System
10K
Freq
AK01
Setup Bank #
A1
Receiver access code
1
0
B1
1
0
S3-1
1
0
Timer
Switch conf.: H,T,B
Main/Aux Aux
only
Save
Cancel
Multibox
Auto Turn Off Active ESTOP
RX Setting
15