Enrange Mini-MBT Instruction Manual
June 2015
Page 35 of 37
8.1 TROUBLESHOOTING OPTIONAL TETHER OPERATION
Problems
Possible Reasons
Suggestions
Transmitter will not
turn on
The connecting tether cable is
not installed, installed
improperly, or is damaged.
Inspect the tether cable and confirm that it is
installed and secured correctly. Inspect the
connector, connector contacts and cable jacket
for damage.
Transmitter is failing switch
scan.
Be sure all switches and motions are in the off
position on startup. See Section 3.2 for more
info.
Transmitter Machine Stop
switch is down or pressed.
Be sure the Machine Stop switch is pulled up.
Transmitter will not
respond with the
receiver in tether
mode
System not in tether mode.
Make sure that the startup procedure is
initiated with the tether cable attached. Ensure
that all tether cable connections are secure
prior to startup.
The tether cable or connectors
are damaged.
Inspect the tether cable and connectors for
damage.
CAN settings are incorrect.
Verify CAN settings match project specific CAN
bus document.
Transmitter will not
respond with the
receiver in wireless
mode
System not in wireless mode.
Make sure that the startup procedure is
initiated with the tether cable detached.
Ensure that the startup procedure is initiated
within 300 feet from the receiver location.
8.2 ASSEMBLY AND REPLACEMENT PARTS
If your transmitter ever needs repair, we always recommend that you have Magnetek perform the repair.
If you need to refer to a parts list, refer to your transmitter’s drawing that was included in the shipment of
your transmitter. Please contact Magnetek’s service department at 1.866.MAG.SERV for information
regarding parts and service.
