Enrange Mini-MBT Instruction Manual
June 2015
Page 19 of 37
4. TRANSMITTER SETUP
The transmitter may have settings changed one of three ways.
The RF channel and access code can be programmed using the IR configuration link with a compatible
receiver. All other settings can only be changed at the factory or with the optional RCP software.
For units with the optional graphic user interface, the Setup Mode can be used to edit configuration
settings such as: Access Code, Channel Select, User Code, Transmitter Time Out, Backlight Time Out,
Password Enable, Change Password, and more. The settings can also be changed with the optional
RCP software.
4.1 TRANSMITTER SETUP SETTINGS WITH STANDARD STATUS
LED
The access code and channel can be changed using the IR configuration receiver link with a compatible
receiver (contact the factory to determine if your receiver is compatible).
4.1.1 IR Configuration Receiver
IR Cfg Recv function allows the transmitter to link to a compatible receiver by using IR (contact the factory
to determine if your receiver is compatible) and automatically set up the channel and access code to
match the linked compatible receiver.
4.1.1.1 IR Configuration Receiver on Transmitters Equipped with Separate Power/Status and
Battery LED Indicators
To utilize the IR configuration receiver function and link to a compatible receiver, push the OFF-ON-
START toggle to the START position and hold for more than 5 seconds. When the transmitter
successfully enters the IR configuration mode, the Power/Status and Battery LED(s) will blink alternately
continuously. After the LEDs are blinking alternately, point the IR window of the transmitter at the desired
receiver to control and momentarily press the OFF-ON-START toggle to the START position and release.
If the link is successful, the LEDs will stop blinking and the transmitter will shut down. The new settings
obtained from the IR configuration function will take effect upon the next power cycle of the transmitter.
If the link is unsuccessful with a compatible receiver, the Power/Status and Battery LED(s) will continue to
blink alternately.
To cancel the IR configuration receiver without a successful link, move the OFF-ON-START toggle to the
OFF position.
4.1.1.2 IR Configuration Receiver on Transmitters Equipped with Single Status/Battery LED
Indicator
To utilize the IR configuration receiver function and link to a compatible receiver, push the OFF-ON-
START toggle to the START position and hold for more than 5 seconds. When the transmitter
successfully enters the IR configuration mode, the Status/Battery LED will blink continuously. After the
LED is blinking, point the IR window of the transmitter at the desired receiver to control and momentarily
press the OFF-ON-START toggle to the START position and release.
If the link is successful, the LED will stop blinking and the transmitter will shut down. The new settings
obtained from the IR configuration function will take effect upon the next power cycle of the transmitter.
