Enrange Flex EM/EX Instruction Manual
April 2019
Page 12 of 19
4. DIP-SWITCH SETTINGS
4.1 SYSTEM CHANNEL SETTINGS
Set the transmitter channel by adjusting the dip-switch bank 2 located on the backside of the transmitter
encoder board (refer to Figure 4). Only the first five positions of the dip-switch are used for channel
programming (refer to Figure 5). The system channels table (Section 6.2) illustrates which dip-switch
setting corresponds to which channel. Once the transmitter channel is altered, the receiver must be set
up to recognize the transmitter on its new channel.
Top slot → “1
Bottom slot
→ “0
Figure 5
The above dip-switch setting
“1 0 0 1 0”
corresponds to “channel 19” in the system channels table
(Section
Error! Reference source not found.
).
4.2 INACTIVITY TIME-OUT TIMER
Bits 6 and 7 on dip-switch bank 2 (refer to Figure 4) allow the user to define a time after which, if no
buttons on the transmitter are pressed, the Flex transmitter will send an OFF command to the receiver
and power down. To restart, the user must turn the On/Off/Start switch to the OFF position, then back to
ON again to resume operation.
Time Out
Dip-switch
Setting
5 minutes
01
10 minutes
10
15 minutes
11
Never shut off
00
Figure 6
