Electrification FS Conductor Bar System Instruction Manual
October 2019
Page
17
of
34
Chapter 5.0: Joint Assembly
5.1: FS-JNTG,
FS-JNTC
5.1.(a):
Verify that the clamping plate is 1/8” below the underside of the joint assembly bracket.
If not, loosen or tighten the nuts to make the adjustment.
5.1.(b):
Slide the joint assembly into upper slot of the end of the line element. Be sure the
clamping plate is properly located in the end of the line element.
5.1.(c):
Slide the next line element into the open end of the joint assembly. Be sure the clamping
plate is properly located in the end of the line element.
5.1.(d):
Center joint assembly over the adjoining line elements.
5.1.(e):
Tighten one nut of the joint assembly 55 in-lb.
5.1.(f):
Verify the end face of each line element is together.
5.1.(g):
Tighten the other nut of the joint assembly 55 in-lb.
5.1.(h):
Verify each nut on joint is tightened appropriately.
NOTE: Tools Required: 3/8” Wrench or Socket
NOTE: A liberal coating of joint compound FS-JNJC is recommended on all mating faces that conduct
current.
5.2:
Joint Covers (FS-JNCV)
5.2.(a):
Open joint end cover on each end of the joint (disengage lower locking tabs from each
side of cover).