Electrification FS Conductor Bar System Instruction Manual
October 2019
Page
14
of
34
Chapter 4.0: Modular Hangers
4.1:
FS-H2, FS-H3, FS-H3L, FS-H4
4.1.(a):
Remove nut(s), lock washer(s) and flat washer(s) from hanger base mounting bolt(s).
4.1.(b):
Assemble hanger base to mounting bracket by inserting hanger bolt(s) through mounting
bracket hole(s).
4.1.(c):
Assemble washer(s), lock washer(s) and bolt(s) to hanger bolt(s) and hand tighten.
4.1.(d):
Assemble the snap-in hangers to the hanger base. Locate and follow the arrows on the
sides of the hangers to properly install to the base.
NOTE: Individual hangers are difficult to remove from the base; they are a one time assembly.
4.1.(e):
Snap line elements into the snap-in-hangers.
4.1.(f):
Verify the alignment of the system and tighten the nuts 15 ft-lb. (180 in-lb.)
NOTE: Tools Required: ½” Wrench or Socket