Magnescale SR27A-AZ Series, Инструкция по эксплуатации

Страница: 42 / 84

10
(E)
SR27A-AZ Series, CH22 Series
2. Adjust the parallelism with respect to the machine guide of the scale rear while measuring the scale
rear with a dial gauge. Tighten the set screws.
<Measurement method>
Measure at two points where the measurement distance is as wide as possible and at the same distance
from the right and left scale ends. If using a scale with intermediate foot plate, be sure to also measure the
intermediate foot plate.
Same distan c e from s c a l e ends
0. 1 MG
Fig. 3- 9
3. Insert the supplied spacer (t = 1.0 mm) in the space between the scale and the scale head, and then
adjust the scale head position while bringing the scale head into contact with the scale.
Spacer
(t = 1.0 mm)
Fig. 3-10
Check that the gap at the two ends is 1 mm using a spacer (with a 1.0 mm thickness).
Unit: mm