LH71A / LH72
(E)
1-1
Read all instructions carefully before use.
This instruction manual is intended for use outside Japan.
The LH71A/LH72 counter unit will benefit you with reduced machining time and higher machining accuracy.
To make full use of the unit’s functions, read this instruction manual through carefully, and keep it properly
for future references.
1-1. General Precautions
When using Magnescale Co., Ltd. products, observe the following general precautions along with those
given specifically in this manual to ensure proper use of the products.
•
Before and during operations, be sure to check that our products function properly.
•
Provide adequate safety measures to prevent damage in case our products should develop a malfunction.
•
Use outside indicated specifications or purposes and modification of our products will void any warranty
of the functions and performance as specified for our products.
•
When using our products in combination with other equipment, the functions and performance as noted
in this manual may not be attained, depending upon the operating environmental conditions. Make a
thorough study of the compatibility in advance.
1. Preface
Содержание LH71A
