MAGNAWELD monoTIG 160i, Руководство пользователя

Страница: 18 / 84

18
www.magmaweld.com USER MANUAL | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
EN
monoTIG 160i / monoTIG 200i
3.1 User Interface
OPERATION
1
2
3
4
5
6
7
8
Setting Function
Selected function buttons selected prometer is increase or decreased.
Welding Mode Option Switch
It is used for decision of MMA welding, TIG welding with HF or TIG welding with scratch modes.
Led for Trigger Mode
Welding current starts when the trigger is pulled and dropped and ends after pulled and dropped again.
Led of MMA Mode
MMA welding mode activated.
LIFT Weld Start
Welding starts with scratch between torch and working piece while the torch trigger is activated.
Selecting Time, Gas and Type of Electrode
Led for Trigger Mode
Welding current starts when the trigger is pulled and stops when the trigger is dropped.
When
9
led is on and machine is TIG mode, welding current can be increased or decreased by
1
.
When
10
led is on and machine is TIG mode, finish ramp time can be set by
1
.
When the machine is in TIG mode, press and hold the pot
1
and the pre-gas setting will be opened. The
pre-gas parameter is adjusted by turning the pot
1
right and left. Press the pot
1
again to exit.
When
11
led is on and machine is TIG mode, post gas parameters can be set by
1
.
2
with this butto, when MMA
4
welding mode is selected
9
is Rutile,
10
is Basic, is Cellulosic can be
choosen with
3
.
HF Weld Start
Welding current starts with high voltage arc voltage arc across the gas without contact between work
piece and torch.
Operation