Step 7:
On the
Right Side
of the machine, lay a
3 ft. straight edge
accross the “Outside Face” of
the “Rear Drive Sprocket” and the “Front Idler”.
Step 8:
Adjust
“Inner” & “Outer” Adjustment
Bolts on right side of the machine
, until straight
edge lays flat on both “Outside Faces.”
(See ad-
justment bolt pictures from steps 4 & 5).
Step 9:
Now move to the
Left Side
of the ma-
chine, and adjust
“Inner” & “Outer” Adjustment
Bolts
, until straight edge lays flat on both “Outside
Faces.”
Step 10:
Double check the “Upper Strands” are
still straight, and there are
NO GAPS
between the
“Front Idlers” and the Rubber Tracks,
on both
sides.
Step 11:
Tighten the 2 bolts that connect the “cen-
ter idler frame” to the “track expander.” Do the
same to both sides of the tractor. (If installed on
your machine.) See picture in the next column.
Step 12: Hand thread,
then using a cordless im-
pact driver or ratchet with 3/4” socket and 3/4”
wrench, tighten the
“Inner & Outer Jamb” nuts
on both sides of the machine
. (A total of 4). See
the two pictures below.
Step 13:
From “outside” the Crawler’s body,
tighten the five nuts on each Front Axle Plate. Do
the same for both sides of the tractor. See the pic-
ture at the top left of the next page.
54
No Gap
Straight
Right Side
“Outside Faces”
Left Side
“Outside Faces”
Track
Expander
2 Bolts
Center Idler Frame
“Outer Jamb” Nut
“Outer”
Nut
Small
Washer
Large
Washer
Front
Axle
“Inner Welded” Nut
“Inner” Adjustment Bolt
“Inner Jamb” Nut
Bolt Adjustment
Plate
“Outer” Adjustment Bolt