10
GB
• Before using the remote control you will need to insert the supplied batteries (accessory
No. 3):
• Use the supplied screwdriver (accessory No. 5) to remove the rear of the remote
control.
• Insert the batteries into the battery compartment. When doing this pay attention to
the correct polarity of the batteries.
• Replace the rear and tighten the screws.
• If the batteries have run out after prolonged use, please replace them (type AAA).
18 Mute
You can mute the sound using this button. The status
indication (front panel, 2) then illuminates orange. The
sound can be reactivated by pressing this button again
(status indication becomes green).
19 Volume
You can use this button to decrease the volume of the
music.
20 Volume
You can use this button to increase the volume of the
music.
• Place the RV 2 on an even surface. Observe the relevant clearance gaps as specified
under "Important safety instructions".
• Connect your speakers as described under (8/9).
Only use high-quality audio speaker cables with a conductor cross section of min. 1.5 -
2.5 mm². Strip approx. 10 mm from the cables and twist the ends. Loosen the terminal
screws one after the other and insert the stripped ends into the holes. Re-tighten the
terminal screws. Make sure you pay attention to the correct polarity.
You can also use prefabricated cables with 4mm banana plugs or forked fittings.
• Connect your audio sources to the analogue connections (10 – 17).
• Connect the supplied mains cable to the rear (7) and then insert the other end into a
230V socket.
• Turn the volume knob to the left to a low volume setting (6).
• Select your desired audio source using the input selector switch (4).
• Switch on the RV 2 using the power button on the front panel (1).
• When the tubes have heated up (LED (2) flashes for approx. 30 seconds) the device is
ready for use.
INITIAL OPERATION
OPERATIONAL ELEMENTS AND CONNECTIONS – REMOTE CONTROL
If it is necessary to replace the tubes, please refer to a specialist dealer.
If you should encounter any technical problems, please contact your specialist dealer or
Magnat Audio-Produkte GmbH, Tel.: 02234807-0.
Amplifier:
Power output:
Rated power
20 Hz – 20 kHz, THD < 1.0%, 4 Ohm
2 x 50 W
20 Hz – 20 kHz, THD < 1.0%, 8 Ohm
2 x 50 W
Frequency response :
5 Hz – 45 kHz (-3 dB)
20 Hz – 20 kHz (-0.5 dB)
Phono
20 Hz – 20 kHz (-1.0 dB)
Signal to noise ratio:
CD/Tuner/Aux/Tape 95 dB
Phono MM
80 dB
Phone MC
70 dB
Input sensitivity/impedance:
CD/Tuner/Aux/Tape 500 mV / 100 kOhm
Phono MM
2.8 mV / 47 kOhm
Phone MC
0.3 mV / 470 Ohm
Equipment
:
Phono input stage:
“Low Noise” Precision OP Amps
Preliminary stage:
2x 12AX7 (ECC 83)
Driver stage:
2x 12AU7 (ECC 82)
Power stage:
4x 6550
Dimensions (wxhxd):
Main device:
403 x 190 x 325 mm
Main device incl. operational elements/connecting terminals: 403 x 190 x 375 mm
Remote Control:
40 x 100 x 16 mm
Weight
:
23 kg
For further information please visit our website: http://www.magnat.de.
Subject to technical change.
SPECIFICATIONS
SERVICE AND TECHNICAL PROBLEMS
TUBE REPLACEMENT
