OPERATIONAL ELEMENTS AND CONNECTIONS – REMOTE CONTROL
• The transparent protective tab on the underside of the battery compartment must be removed before
using the remote control.
• If the batteries have run out after prolonged use, please replace them (type CR2025).
• To prevent causing damage to the remote control please remove the batteries if the device is not
going to be used for a prolonged period.
1 MASTER / 2 AMP
Switches the device on when it is in the standby mode.
If the LED does not illuminate, actuate the power switch
located on the rear of the device. Conversely the device
can be switched from power operation to the standby
mode.
The MASTER button also switches other units in
Magnat's M400 series (MCD 450, MT 420) on and off.
3 INPUT SELECTON
These buttons enable direct selection of the individual
audio inputs. The active input is indicated in the display.
4 MENU
Launches the menu for adjusting tone and for
configuring the inputs. Navigate through the menu with
the VOLUME keys.
5 VOLUME
Increases (
) or decreases (
) the volume.
6 MUTE
Switches the sound on and off.
The non-numbered buttons are reserved for operating
the Magnat CD player MCD 450 and the Tuner MT 420
and have no function for the MA 400.
INITIAL OPERATION
• Place the MA 400 on an even surface. Observe the relevant clearance gaps as specified under
"Important safety instructions".
IMPORTANT
: Do not place any objects on top of the device (magazines, CD/record cases, etc.).
The ventilation slots located on top of the device must be unobstructed at all times!
• Connect your speakers:
The stereo speakers (impedance of 4 to 8 ohms) are connected to the rear as follows:
Only use high-quality audio speaker cables with a conductor cross section of min. 1.5 - 2.5 mm².
Strip approx. 10 mm from the cables and twist the ends. Loosen the terminal screws one after the
other and insert the stripped ends into the holes. Re-tighten the terminal screws. Make sure you
pay attention to the correct polarity.
You can also use prefabricated cables with 4mm banana plugs or forked fittings.
Also observe the operating instructions for the speakers you are using.
• Connect your audio sources to the analogue connections.
• Connect the supplied mains cable to the rear and then insert the other end into a 230V socket.
• Actuate the on/off switch on the rear side, the device is now in the standby mode.
• Now switch on the device using the remote control or with the ON/STBY key on the front.
• When the tube has heated up the device is ready for use.
• Select your desired audio source using the input selector switch.
GB
9
