Magmaweld MONOSTICK 200i PFC, Руководство пользователя

Страница: 23 / 36

21 MONOSTICK 200i PFC
SAFETY RULES
FALLING UNIT CAN CAUSE INJURY
Wrong positioned power source or other equipment may cause serious injury to persons or damage
to objects
.
Ÿ While repositioning the power source always carry by using the lifting eye. Never pull cable, hose or torch.
Always carry the gas cylinders separately
.
Ÿ
Before carrying the welding and cutting equipment, disassemble all the connections between and
separately carry the small ones by handgrips and the big ones by lifting eyes or by using appropriate
vehicles like forklifts
.
Ÿ Install your machine on flat platforms having maximum 10° slope that it does not fall over. Install it on well
ventilated, non-confined places away from the dust, also avoiding the risk of falling caused by cables and
hoses. For gas cylinders not to fall over, attach it to the mobile machine or to the wall with a chain
.
Ÿ
Ensure that operators easily reach the controls and connections on the machine.
OVERUSE CAN CAUSE OVERHEATING
Ÿ
Allow cooling period; follow rated duty cycle .
Ÿ
Reduce current or reduce duty cycle before starting to weld again .
Ÿ
Do not block airflow t hrough the unit.
Ÿ
Do not filter airflow to unit without the approval of manufacturer
.
ARC WELDING CAN CAUSE INTERFERENCE
Ÿ
According to TS EN 55011:2007 standarts this machine is in the scope of group 2, class A.
Ÿ
This class A machine is produced for the residential area, that takes energy from low voltage network. in
such areas there may be possible difficulties to comply with electro magnetic compatibility. like radio
frequency parasitics. Conducted and radiated.
Ÿ
This equipment does not comply with IEC 61000-3-12. The user or installer should have
information about connectivity of the machine, if it is connected to a public low voltage system.
Ÿ
Be sure all equipment in the welding area is electromagnetically compatible . Electromagnetic energy
arising during welding and cutting operations can interfere with sensitive electronic equipment such as
microprocessors, computers, and computer-driven equipment such as robots
. If interference still occurs,
the user must take extra measures such as moving the welding machine, using shielded cables, using line
filters, or shielding the work area
.
Ÿ
To reduce possible interference, keep weld cables as short as possible, close together, and down low, such
as on the floor
.
Ÿ To avoid possible EMC damages, locate welding operation as far as possible (100 meters) from any
sensitive electronic equipment
.
Ÿ
Be sure this welding machine is installed and grounded according to this manual .