Magmaweld ID 65 PX, Руководство пользователя

Страница: 15 / 248

EN
15
www.magmaweld.com USER MANUAL
ID 65 PX / ID 65 P
INSTALLATION
2.1 Delivery Control
Make sure that all the materials you have ordered have been received. If any material is missing or damaged,
contact your place of purchase immediately.
The standard box includes the following;
• Cutting machine and connected mains cable • Warranty certificate
• Torch and consumables • User manual
• Workpiece clamp and cable
In case of a damaged delivery, record a report, take a picture of the damage and report to the transport
company together with a photocopy of the delivery note. If the problem persists, contact the customer service.
2.2 Installation and Operation Recommendations
Symbols and their meanings on the device
Cutting / welding may be dangerous. Proper working conditions should be ensured and necessary
precautions should be taken. Specialists are responsible for the machine and have to be equipped with the
necessary equipment and those who are not relevant should be kept away from the cutting / welding area.
This device is not compatible with IEC 61000-3-12. If it is desired to connect to the low voltage mains used
in homes, it is essential that the installer or the person who will operate the machine to make the electrical
connection has information on the machine’s connectivity. In this case the responsibility will be assumed
by the person who will perform the installation or by the operator.
The safety symbols and warning notes on the device and in the operating instructions must be observed
and the labels must not be removed.
Grids are intended for ventilation. The openings should not be covered in order to provide good cooling and
no foreign objects should be inserted.
• Lifting rings or forklifts should be used to move the machine. Place the power supply on a hard, level, smooth
surface where it will not fall or tip over.
• For a better performance, place the machine at least 30 cm away from the surrounding objects. Pay attention
to overheating, dust and moisture near the machine. Do not operate the machine under direct sunlight. If the
ambient temperature exceeds 40°C, operate the machine at a lower current or a lower operating cycle.
• Avoid cutting outdoors in windy and rainy weather circumstances. If cutting is necessary in such cases,
protect the cutting area and the cutting machine with a curtain and canopy.
• When positioning the machine, make sure that materials such as walls, curtains, boards do not prevent easy
access to the machine’s controls and connections.
• If you cut indoors, use a suitable fume extraction system. Use breathing apparatus if there is a risk of
inhaling cutting fumes and gas in confined spaces.
• Observe the operating cycle rates specified on the product label. Suspending operating cycle rates can
damage the machine and this may invalidate the warranty.
• The supply cable must comply with the specified fuse value.
• The power supply must be grounded in accordance with local and national electrical codes.
• Make sure the gas supply connections are made correctly. If the gas source is compressed in the cylinder, fix
the gas cylinder so that it does not tip over.
Installation