EN
www.magmaweld.com
25
USER MANUAL | MANUEL D’UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
SMART SERIES / SMART SERİSİ
7-) PROGRAM SELECTION
8-) TRIGGER MODE SELECTION
It is used to record the work done. There are 3 memories. The LED of whichever program is processed (7) will burn.
To save the program, it is necessary to press the button once and switch to the other program. If you are going to record in the program number 3, it will
be enough to press the button once to save your settings after the P3 led is on. Thus, all program leds will be off.
After the P3 program, there is an area that allows the program to work without registering. While in this area, the program will not be recorded and
the program leds will be off.
Setting Range
• P1 - P2 - P3
Trigger mode selection will be made. Each time the button
(8)
is pressed, the other trigger mode is switched.
Setting Range
• 2 Trigger
• 4 Trigger
• Method
2 TRIGGER MODE:
When the torch trigger is pressed, welding starts and the trigger will be held pressed until the welding ends. Releasing the trigger
will end the welding.
Welding Start;
Welding Termination;
• Press and hold the torch trigger.
• Release the pressed torch trigger.
• Shielding gas flow starts as long as the pre-gas period.
• The wire feed motor will stop.
• At the end of the pre-gas period, the wire feed motor runs at a slow speed.
• The arc extinguishes after the set burn-back time.
• Welding current increases when the workpiece is reached.
• The process ends after the final gas period.
PrG
: Initial Gas Time
I
: Welding Current
PoG
: Final Gas Time
Press the Trigger
Hold the Trigger Pressed
Release Trigger
Operation
Содержание ID 500 M PULSE SMART
Страница 159: ......
