Following are the wiring connections for several brands of timers. If your timer is not
listed, consult your supplier for further information.
3)
DISPLAY PANEL AND PUSHBUTTONS
The iCoin utilizes a display and pushbuttons for configuration settings, current
settings, and self-diagnostics. The display has several indicator lights that show
which currency coins the iCoin is currently accepting and setup information
regarding tokens. The pushbuttons allow one to change the coins that are to be
accepted and to set the tokens (if any) that the iCoin is to accept. Pushbuttons are
labelled with the function that they provide as well as a number. For convenience,
this manual will include in parenthesis the number of the pushbutton in addition to
the label of the pushbutton.
Immediately during the first 10 to 15 seconds of power up, the iCoin display will
sequence through the current configuration settings. These settings are covered
later in
Section 8) Configuration Settings
. Following this the display shows which
preprogrammed currency coins it will accept as well as if there are any learned
tokens that it will accept.
By default the iCoin power saving mode is enabled so that if there is no activity for
a period of time, either coins being accepted or pushbuttons pressed, then the
acceptor will enter a power saving mode where the display will flash the
preprogrammed coins and token settings repeatedly. Once a coin is dropped or a
pushbutton is pressed the display will turn on steady until the period of time
elapses again at which time the acceptor will again enter the power saving mode.
The period of time by default is 1 minute. You can learn how to change this value in
Section 8) Configuration Settings
.
Power
Electronic Pulse
Relay Pulse
Timer
Yellow
Black
Blue
Purple
Red with
green
stripe
Red with
green
stripe
Magikist
MT580 or
MT580U
24VAC
Hot #2
COMMON
#3
COIN
#6
N/C
COIN
#6
COIN
SWITCH–
#7
Magikist
MTV840
Yellow
-Black
+Blue
N/C
+Blue
-Black
Magikist
MTV600
24VAC
HOT OUT
#3
COIN
SWITCH–
#8
COIN
#7
N/C
COIN
#7
COIN
SWITCH–
#8
Dixmor
LED7
red
green
brown
N/C
brown
grey
Grace Timer
or PEM7
#3
#1
#4
N/C
#1
#4
