Magiglo ACCOLADE, Инструкция для пользователя, установки и обслуживания

Страница: 33 / 48

Page 29
3.9. Installation Procedure
Before commencing installation, ensure that the intended installation will comply
with details in
X
General Information
X
on Page
X
1
X
.
The Burley Magiglo Accolade is designed to be inset into a 16” fireplace opening.
Any surround that is to be installed with this fire must be rated at 150
o
C.
Carefully unpack the contents of the carton and check them against the checklist given on the
previous page.
Make sure that the fireplace opening is suitable for the installation of the fire and prepare the
fireplace to suit the dimensional requirements given in sections
X
3.2
X
,
X
3.3
X
and
X
3.4
X
.
3.9.1. Preparing the Firebox
1. Remove the front plate by removing the
two fixing screws (see
X
Figure 51
X
).
2. Remove the three tray fixing screws
located under the front corners of the
tray (see
X
Figure 52
X
).
3. Withdraw the burner from the firebox,
taking care not to damage the ceramic
back and side panels. Place the burner
away for later use.
4. Apply the foam sealing strip all round the
rear edge of the firebox flange by
removing the protective backing paper
(see
X
Figure 53
X
).
5. Unpack the cable fixing kit and feed the
cable ends through the top holes on the
sides of the flue outlet (see
X
Figure 53
X
).
Ensure that the ceramic back is not
scuffed whilst pulling the cables through.
WARNING: Do not block the
four oblong holes at the back of
the firebox.
Front plate fixing
screws
Figure 51
Tray Fixing
Screws
Figure 52 - Tray fixing Screws on Manual Control Model
Sealing strip
Cables
Figure 53