MAGIDO GROUP X51 Series, Руководство по эксплуатации и обслуживанию, Страница: 85 / 96

MAINTENANCE AND REPAIRS
REVISIONE: X51-1213 EN 30 MAGIDO GROUP S.r.l.
Trouble shooting
A number of possible inconveniences that may occur on the machine are listed below.
PROBLEM
CAUSE
CAUSE SOLUTION
1- The machine does not start
Main power supply fuses have blown Change
Bad connection between machine and
main power supply
Reset
Step down transformer fuse has blown Change
2- The pump does not start
Timer has not been set Set
Circuit breaker not engaged * Engage
Lid not close properly Close
3 – The heater does not heat
up
Fuses F1 have blown Change
The thermostat is defective Change
Heater element burnt out Change
Weekly timer (optional) not set Set
4 – The basket does not rotate
Excessive load Decrease the weight
Load not uniformly distributed Correct
The spray nozzles are clogged Clean
Pump rotates in the wrong direction Invert rotation
Filter is dirty or obstructed Clean
Lower spray tube is not regulate Set
Basket brake is defective Control
5 – Incomplete wash
Wash time too short Increase time
Wash solution too dirty Change solutions
The spray nozzles are coggled Clean
Filter is dirty or obstructed Clean
Basket does not rotate See point 4
Pump rotates in the wrong direction Invert rotation
Not suitable detergent Change
6 – Pump leaks water Mechanical seal is worn Replace
In case of electrical overload the pumps and motors may stops.
In this case re-engage the circuit breakers by pushing the ON button on circuit breaker itself.
In case of continuous anomaly have the cause verified by a qualified electrical technician