![background image](http://html1.mh-extra.com/html/magicfx/shot-base-dmx/shot-base-dmx_manual_3496435019.webp)
User documentation MAGICFX® Shot Base DMX
Page 17
After using the Shot Base DMX the
machine must be set in the safe mode
again.
Put the Shot Base DMX in the safe mode
by closing the
‘Safety’ channel or by
giving it a value outside the 40-60%
range.
The Shot Base DMX cannot be used when it
is in the safe mode.
Before you start firing the canons always
check to make sure that nobody is
situated within the output direction of the
Shot Base DMX. Also always make sure
that there is a good view on the Shot
Base DMX during the special effect.
Consult the manual of the DMX controller for
correct use.
To get the Shot Base DMX out of the safe
mode, the ‘safety’ channel on the Shot
Base DMX must be set between 40% and
60%.
The LED light on the back of the Shot
Base DMX now starts to flash on and off.
Press the flash buttons of the set output
channels on the DMX controller.
The cannons connected to the Shot Base
DMX now go off if the right output has
been chosen.
4.
Then connect the connectors of the
cannons to the accompanying output.
If the cable is too short then use the cable
extension provided.
If you cannot insert the connector properly in
the output then squeeze the front piece of
the connector tightly so that it will properly go
into the output.
3.
Содержание SHOT BASE DMX
Страница 1: ......
Страница 2: ...PRODUCT CODE MFX0350 VERSION 1 0 DATE 26 02 2013...