Magicar m110as bruger, Руководство пользователя

Страница: 14 / 23

Two-Way Remote User’s Guide
28
Two-Way Remote User’s Guide
27
Option Functions
Warning of vehicle battery drain.
Two-Way Remote User’s Guide
26
One flashing light
Trunk Open Sensor
If the vehicle is locked (armed) with a taillight on, the parking lights will flash once
and siren will chirp 7 times
With this sensor installed and the alarm armed, the alarm will be triggered if the trunk
is opened. The siren will be activated and the parking lights will flash.
Wakeup Interception Function
With this option installed: If the door is forced open, while the vehicle is armed/locked,
the vehicle will not start with either the remote or key.
Preheating Sensor
For remote starting diesel vehicles, the system monitors Wait to start lights to preheat
the engine.
Options will generally cost extra for installation and parts.
Note
Two-Way Remote User’s Guide
25
~Beep once
Flashes 5 times
2. Button Hold Cancellation
To cancel the Button Hold function, press button
IV
for 2 sec. again while the
Button Hold function is active. The remote will beep twice, and the normal func
tions will return to the remote.
3. Button hold Display
Normally, Button Hold operation is indicated on the right side of the screen as
an
“
H
”
The Button Hold function will be cancelled if you activate Panic mode by
pressing button
IV
for 4 sec.
Note
Button Hold Function
2 sec
Button Functions
This function prevents accidental button presses while carrying your remote.
1. Button Hold Set-up
To activate the Button Hold function, press button
IV
for 2 sec. The remote will
beep and display
“
Hold
”
on the screen.
~Beep once
Flashes 5 times
2) Button Hold Cancellation
To cancel the Button Hold function, press button
IV
for 2 sec. again while the
Button Hold function is active. The remote will beep twice, and the normal func
tions will return to the remote.
3) Button hold Display
Normally, Button Hold operation is indicated on the right side of the screen as
an
“
H
”
The Button Hold function will be cancelled if you activate Panic mode by
pressing button
IV
for 4 sec.
Note
2 sec
Button Hold Functions
This function prevents accidental button presses while carrying your remote.
1) Button Hold Set-up
To activate the Button Hold function, press button
IV
for 2 sec. The remote will
beep and display
“
Hold
”
on the screen.
Double Tap
If it is hard to see the screen because of low light conditions, tap button
III
twice, the
EL Lamp will be turned on.
~Beep
EL Lamp is
turned on
3) Turbo Time Extension
Pressing button
I
for more than 2 sec. while the turbo timer is operating will
extend the run time, as is scrolled across the display.
A turbo timer is designed for vehicles with turbo chargers. After hard use,
the turbo housing will be very hot and allowing the vehicle to idle for a few
minutes will cycle more oil through the turbo while it cools.
Turbo Function works differently with LPG option vehicles.
Warning! Since engine is running without key with this Turbo Mode, the dri
ver should make sure that the vehicle
’
s gear is in neutral.
Note
~Beep twice, 4 times
(1:57 will be displayed when 2 minute Turbo
Timer is activated)
EL Lamp