4. Slide a hose clamp over the end of the drain hose. Attach the
drain hose to the sink connector, slide the hose clamp to the
end of the hose, and then tighten the hose clamp.
NOTE:
You must use a hose clamp. Failure to do so may cause
water leakage.
5. If there is no air gap, make sure to hang the middle of the drain
hose well above the sink cabinet base to prevent back flow
(see Figure 9).
6. When drilling a hole for the drain hose on the cabinet wall, take
caution not to damage the drain hose by sharp edges of the hole.
On wooden walls, use sanding to soften the edges. On metal walls,
use insulation tape or duct tape to cover the sharp edges around
the hole.
7. Take caution not to damage the drain hose when installing the dishwasher on the floor, wall, or cabinet.
To prevent leaks or drainage problems, make sure the drain hose is not damaged, kinked, or twisted.
8. Do not cut the wrinkled area of the drain hose to fit the size. When arranging the drain hose, take caution
not to make contact with any sharp edges of the cabinet or under-sink.
Figure
8
Hose
Clamp
Sink
Min. 20 in
(508 mm)
Dishwasher
Drain Hose
Min. 30 in
(762 mm)
Figure
9
11
